Psensor is a GTK application that shows graphs of CPU, GPU, hard drive temperatures, and fan speeds, including remote computers if needed. It is possible to correct inaccurate scaling too. The sensor output may be tweaked by editing the "/etc/nf" file. AUX Temp and Case/Aux Fan) this tends to be the case with at least some of the sensors on most motherboards. As you can see, some sensors are obviously incorrect (e.g. The motherboard sensor device has information on the voltages received from the power supply unit by the motherboard (in1-6), the fan speeds (entries with RPM), and various internal temperatures. This sensors output shows four devices: w83627dhg-isa-0290 (motherboard sensors) and coretemp-isa-0000 through 0004 (Intel Core sensors). Example output is below: w83627dhg-isa-0290 Run the "sensors" command and check the output. Next, you should test that lm-sensors works correctly. You may want to run 'service kmod start' to load them. Monitoring programs won't work until the needed modules are loaded.Type "yes" to have sensors-detect insert those modules into /etc/modules, or edit /etc/modules yourself. At the end of sensors-detect, a list of modules that needs to be loaded will displayed.Run sudo sensors-detect and choose YES to all YES/no questions. Install the lm-sensors package (see InstallingSoftware). Monitoring sensors via the command line with lm-sensors Ubuntu can monitor CPU and other system temperatures, fan speeds, and voltages via command line, using the package lm-sensors, or via GUI applets in your desktop. Reinitialization after suspend to RAM/Disk. Controlling fanspeeds according to sensor values.Monitoring sensors via the command line with lm-sensors.This will give an output similar as shown here for sensors: ~$ sensorsĬonfiguration of lm-sensors is done by configuration files in /etc/nf and in /etc/nf (for details see manpage for nf). To run these programs open a terminal and type the name of the application (including optional parameters, see manpages for details). and more (see lm-sensors documentation for details).pwmconfig: tests the PWM outputs of sensors and configures fancontrol.fancontrol: calculates fan speeds from temperatures and sets the corresponding PWM outputs. sensord: daemon to periodically log sensor readings to syslog.sensors: shows the current readings of all sensor chips.Included are several applications that run from the command line: Is a set of tools to control and view sensors that may be present on your hardware.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |